Skip to content

Radiators: Aluminum vs. Brass

2010 March 30
by admin

There is an age-old debate about which material is better to make radiators from:  brass or aluminum. Most people focus on the radiator core design when choosing a radiator – how many tubes, tube size, how many fins per square inch, etc. – but the core is not the only part of the radiator that can cool. The sidetanks hold more of the cooling fluid than the core!

Just about every high-performance vehicle you see in car magazines has an aluminum radiator. So you might assume that aluminum has the best cooling properties. That actually isn’t true, and we’d like to share some facts and test data that compare aluminum to brass, and even to composite radiator sidetanks.

Heat rejection is the term for measuring the ability of a material to transfer heat to the air. This is what a radiator’s job boils down to: Take engine heat that has been transferred to the engine coolant and transfer it to the atmosphere. Heat rejection is measured by the amount of British Thermal Units (BTU) per hour the system can dissipate. Higher BTU/hour means more heat transfer and better cooling.

Brass radiators came in nearly all vehicles until the ‘80s. A typical original-equipment brass radiator rejects heat at a rate of about 1,500 BTU/hour. That’s pretty good, and this is why brass was chosen as the material for radiators. In the ‘80s, car manufactures wanted to reduce costs and lower vehicle weight. This led to changing the radiator design to use composite (plastic) tanks with an aluminum core. The plastic tanks transfer about 1,000 BTU/hour; considerably less than the traditional brass construction. Next we come to aluminum radiators. It might surprise you to learn that the typical, smooth aftermarket aluminum radiator tanks dissipate heat at a rate of about only 700 BTU/hour! That’s less than half the BTU of brass sidetanks!

When we decided to start engineering our Flex-a-fit radiators, we saw an opportunity to greatly improve heat transfer in the tanks, which is where most of the coolant is in a radiator. We also realized that we could make it easier to mount the radiator, cooling fans and other related components. We make the tanks from extruded aluminum rather than sheet aluminum. The design has cooling fins on the inside of the tank to greatly increase the surface area that contacts the hot engine coolant. Greater contact surface means more heat transfer. On the outside, we use a T-channel design that both adds surface area and provides slots that securely hold fasteners for brackets.

The result from a cooling standpoint is a radiator tank design made from aluminum that transfers over 2,000 BTU/hour! That’s 135 percent more efficient than a typical aftermarket aluminum radiator tank and 41 percent more efficient than a brass radiator tank.

You can learn more about Flex-a-fit aluminum radiators by clicking here.

Add to FacebookAdd to DiggAdd to Del.icio.usAdd to StumbleuponAdd to RedditAdd to BlinklistAdd to TwitterAdd to TechnoratiAdd to Yahoo BuzzAdd to Newsvine